Onsra Velar rear fender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear fender for Onsra Velar
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Simple rear fender for Onsra Velar. Replaces existing belt covers.
Update: 1000km later and these are still in place. I printed with just simple PLA with low infill. Something broke loose in one of the fenders inside in the infill but it has not been an issue. Might print new ones for next year with 10% infill instead of 5%. 😁
Update 2: … and 100km later it finally broke. Now testing PETG variant with bit more infill and the v2 model that is a bit stronger from the point where it failed.
Update 3: I added a shorter more lighter version, might have been bit of a overkill to make it as long as it was previously
Update 4 (2026-07-26): Added a variant of the short version which now requires longer screws so you need to source these from somewhere else (I have not yet printed this, I just started using the previous versions and did this improvement based on what broke on my last prints 😂