Alpha Bit Holder 1/4"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
10-compartment bit holder with easy access from the side or from the top,
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello,
I have made this 10-compartment bit holder with easy access from the side or from the top,
facilitates bit identification,
uses little material and a comfortable fit for tool storage and organization systems.
is inspired by another commercial design, but was improved by adding attachment points.
the fastener has been tested for several days and after multiple optimizations the grip is good over time, it is recommended to use rigid materials that do not deform over time, however PETG works well even PLA but not guaranteed to be the best material.
There are two versions, one for adapters or special bits with through hole and a simple one.
NOTE: you should print using support so that the small clips are with the highest resistance of the material in XY.