Filament cooling and speed overhang calibration test
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple 40x40mm to 120x120mm 45° overhang test, made to figure out where cooling becomes insufficient and corners curl
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 269
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Public Domain
This is a simple test to figure out where cooling becomes insufficient and corners curl when printing overhangs.
It goes from 40x40mm at the base up to 120x120mm at the top with a 45° overhang to test when corners start curling with different filament temperature, part cooling fan percentage, as well as at different print speeds.
Simplest way to test curling causes and also see impact on the on inner corners as well with 5mm walls.
If you want to take it even further, you can add a cube to the center of it to get a tower-curl test at the same time. Might add a V2 of it with a center-box later.
Please enjoy and feel free to remix it.