1 / 6
Qidi Plus 4 Spool Holder 3KG -> 1kg Bearing Mod — zdjęcie 1
1 / 6

Qidi Plus 4 Spool Holder 3KG -> 1kg Bearing Mod

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mod to QIDI Plus 4 3kg Spool Holder to use 608 bearings and fit 1kg spools.

Ocena
5 / 5
Polubienia
16
Pobrania
84
Wydruki
1
Wyświetlenia
714
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Big fan of FxWoody's design, printed the original model in PETG-CF. 

Decided to remix because I don't use 3kg spools yet…? and wasn't a huge fan with taking the front support off every spool change. Designing a side mounted spool holder with bearings was on my to do list. 

The nice part of the original design with the threaded spool shaft makes this versatile. I can run 1kg spools with this and swap it out to the original with front support to use 3kg spools. 

I used (2) 608 Bearings and (3) M3 x 8 socket head screws. Has 3mm ID holes that are 10 mm deep and the end cap has 3mm thick seat, so you could use 8-12mm long screws. No printed threads, the screws cut their own, just don't over torque them. Might be able to get away with 2mm heat inserts if desired.

Couple items to note. 

  • Tolerances are tight with PETG-CF, intentional snug fit but does not restrict bearing movement in anyway.
  • The thread from the original design didn't print too well for me, it was a fight to mate both versions to the base. I tried to trim the mounting threads down a little bit to help but still ended up being difficult. Trick I used to help was to add some rubbing alcohol on the threads and worked the screw back and forth which allowed the threads to form/melt/mold to each other. Worked it back and forth until enough material is shaved off for it to easily thread on. Note I have only tried this on PETG not sure if it will work with stronger material. 
  • STL is provided as an assembly, need to split parts and orientate. 
  • No supports needed.
  • Nothing special with print settings, used my tuned filament/printer settings. I believe I used standard 15% infill and 3 Walls.

Tagi