25mm fan housing for Sony G70 CRT Projector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement fan housing for mounting 25mm fans in a Sony VPH-G70 CRT projector
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The mid-90s Sony VPH-G70 CRT projector comes with three quite noisy 120x38mm fans by default. Since 38mm fans are getting rarer, especially those specifically engineered to be as quiet as possible, I wanted to try using modern 25mm fans in my G70.
This model is essentially just a shorter recreation of the stock fan housing.
I made a model with cable clips, but it did not print right, so I removed them. I added them back later, but have not tried to print that model since I could easily fix the cables with the nearby binding posts. Feedback is welcome!
Obviously, use at your own risk. 25mm fans tend to move less air than their thicker cousins, so there's no guarantee this mod still provides sufficient cooling as intended by the G70's designers. I had this running in my G70 for around two hours at a time without issue, and going by the amount of dust I removed from behind the old fans when installing the new ones, I'm sure my G70 now has more airflow. But as always, YMMV.
You probably should print this in PETG or ABS or something that's more heat resistant than PLA. I printed them in PLA because I like to live dangerously.
Fan used in the photos is the Noctua NF-A12x25 FLX.