NodeCube RAK19007 RAK4631 Meshtastic Solar Node

This is a compact solar Meshtastic node for outdoor use.

Materials List:
RAK19007/RAK4631 Meshtastic Board
Battery with JST PH2.0 Connector (I used the Qimoo 115659 5000mAh 3.7v LiPo)
915mHz LoRa Antenna (I used this: https://www.amazon.com/dp/B0CTXL61LY)
SMA Male to IPEX Cable (came with above antenna)
5V Solar Panel (I used this: https://www.ebay.com/itm/236044764436)
3/4 EMT Metal Conduit (to be used as a pole to mount it on)
ASA 3d Printer Filament (about 200grams)
TPU 3d Printer Filament (about 15 grams)
(6) M3x10mm SHC Screws
(4) M2.5 Phillips screws that come with RAK19007
(4) M2.5x8mm SHC Screws
(2) M4x12mm SHC Screws
JB Weld (Original formula)
JST ZH1.5mm 2PIN Micro Male Cable

Print List:
NodeCube Main Body (ASA)
NodeCube Battery Retainer (ASA)
NodeCube Lid (ASA)
NodeCube Panel Mount (ASA)
NodeCube Antenna Sleeve (ASA)
NodeCube Lid Gasket (TPU)

Assembly:
- Verify the polarity on the battery cable that it matches the RAK. You may need to
switch the cable around.
- Place the battery inside the main body.
- Place the battery retainer over the battery and screw down with M2.5x8mm screws.
- Mount the RAK to the underside of the lid with the supplied M2.5 screws.
- Mount the supplied BTE antenna to the underside of the lid and attach to RAK.
- Mount the SMA antenna post into the hole in the lid and screw it down with the SMA nut/washer.
- Carefully seal the antenna post hole with JB Weld inside the lid to make watertight.
- Install the antenna on the SMA post.
- Install the antenna sleeve (optional) over the antenna and JB Weld to seal it to the lid.
- Place the lid on top of the cube, and insert the solar panel mount into the cube.
- Place the solar panel onto the mount, and line it up for proper placement where it will not
interfere/run into the antenna.  Mark how it should be placed after being JB Welded.
- Remove the solar panel and mount, and JB Weld the solar panel to the mount liberally.
- Run the power wires from the panel thru the hole in the lid.  JB Weld on the inside to seal 
the hole from water.
- Solder the JST ZH1.5mm male connector to the end of the solar panel power wires.
- Connect the antenna IPEX connector to the RAK board.
- Connect the BTE antenna IPEX connector to the RAK board.
- Connect the battery to the RAK board.
- Connect the solar JST connector to the RAK board.
- Install the lid gasket into the recess on the top of the cube.
- Install the lid and screw down with M3x10mm screws.
- Install the panel/panel mount into the sockets on the front of the cube.
- Screw down the panel mount with M4x12mm screws.

Installation:
- Drive the 3/4 EMT metal conduit into the ground.
- Place the NodeCube over the conduit into the 3/4" socket on the rear of the cube.
- Clamp down the NodeCube with two M3x10mm screws.