1 / 3
Warp-weighted tablet-weaving loom v1
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My attempt at a 3d printed version of the Better Loom (http://www.theloomybin.com/doc/cwloom/betterloom2.html)
- Ocena
- 4 / 5
- Polubienia
- 43
- Pobrania
- 94
- Wydruki
- 2
- Wyświetlenia
- 1001
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 2) (Komentarze: 5)Remiksy (0)Kolekcje (73)Powiązane
My attempt at a 3d-printed version of the Better Loom (http://www.theloomybin.com/doc/cwloom/betterloom2.html). It uses a grooved bar rather than a spring to keep threads organized, and a ratcheting bar makes it easy to advance the weaving as it's completed.
It's usable as-is, but it's a first attempt and there are aspects that could be improved, most notably:
- The tabs for C-clamps are very small and the ratcheting gear hasn't got much clearance, so there isn't room for more than a 1" c-clamp. A spring clamp should work, or raising the gear a little.
- There's no need for the rear rod to be slotted where it intersects the two back brackets.
- Something should be inserted into the slot on the front rod to keep it from bending inwards, or the slot's width should be reduced. It's quite flexible right now.
- The handle to turn the gear isn't necessary and gets in the way