Thread Cone Holder/Stand for Janome HD-3000
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A thread cone holder that can be attached to the Janome HD-3000 in two places. Half-inch PVC is required.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 316
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
I wanted to attached a thread cone to my HD-3000. There are no convenient screw locations that can be used for this sort of thing. While experimenting with potential mounting locations, I created models for the vertical spool socket and for the side of the machine above the hand wheel.
The mounting portions are separate from the actual cone holder. The cone holder attaches to either base using an M5 machine screw.
I just used some scrap ½" PVC that I had laying around. The PVC acts as a spindle for the cone and also a support for the thread guide.
Considering neither mounts are mechanically attached to the sewing machine, you may need to experiment a little to ensure stability. I personally don't have any problems with the small-ish cones that I currently use.
I just used a basic 0.2mm profile. I print a bit fast, which adds some slop, but it makes for a snug fit for the machine screw and the PVC. Make sure to orient them in a way that makes sense. No support should be required.