NIIMBOT D11 Holder for Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snug fitting Skadis sleeve holder for the newer version of NIIMBOT D11. This is for the D11 version that has USB-C plug.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- GNU General Public License v2.0
After being frustrated at the lack of SKADIS options that fit my version of the NIIMBOT D11 thermal printer, I ended up remixing the closest model I found to what I was looking for (see link for the original author's model).
The issue is that there are at least 3 different version of the NIIMBOT D11. And they all seem to be a different shape :-(.
To be clear, the version of the D11 that will fit my model technically is called D11_H. It has only been introduced since around 2023. It has a USB-C plug. The front has no buttons whatsoever. The strap is on the left side. See my photos. I say all of this because there are 3 variations out there and only the one described above will fit my model.
Note that I prefer to have my SKADIS accessories fit very securely. So if you find the hooks fit too tightly for your tastes, you may need to sand them down slightly. Tested with both a 3D printed SKADIS and an official IKEA SKADIS board as well.