Light Storm LS1 Magazine
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a printable version of the magazine used by the Light Storm LS1. It holds 5 darts, and feeds just as smoothly…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 314
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
This is a printable version of the magazine used by the Light Storm LS1. It holds 5 darts, and feeds just as smoothly as the original magazine does.
This project requires the following hardware to be assembled:
1 constant force spring, aka a drum replacement spring
https://outofdarts.com/collections/springs/products/replacement-drum-spring-created-by-foamblast
4 2-56 Thread, 3/16" Long screws
https://www.mcmaster.com/91772A076/
OPTIONAL
Instead of using 3/16" Long screws for the bottom 2 screws, you can also use 2 2-56 Thread Size, 11/32" Long screws. They will add some strength to the assembled magazine.
https://www.mcmaster.com/91772A506/
Printing:
Both The Left and Right pieces of the magazine are best printed standing up vertically. Any sort of support will work, but if you use traditional support, you will have to carefully remove the small amount of support where the spring slots into the Left piece.
The follower should be printed on its side with the wide slot facing up.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Doesn't Matter
Supports:
Yes
.12 mm
Infill:
10%
How to install the constant force spring.
How to place the Follower on the constant force spring. Make sure that the angled end of the follower is on the same side as the notch in the Left piece, and that the spring fits into the groove on the side of the Follower.
Category: Mechanical Toys