1 / 3
SimLab XP1 Pedal Hole Plug/Filler Sim Racing
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Plugs to fill the holes on Sim Lab XP1 sim racing pedals.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 301
- Wydruki
- 0
- Wyświetlenia
- 908
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (16)Powiązane
Changelog:
- 2025-04-25
- Added [XP1 Plug - Angled Print - Short Curved - Bolt in Lower Hole]
- Note this hasn't been tested yet
- Due to the Bolt, there has to be a big hole. The only way to make the big hole smaller is to make the plug protrude out of the face of the pedal.
- 2025-04-24
- Added [XP1 Plug - Angled Print - Tall Curved - Bolt in Lower Hole]
- Will see about a version for the short curved where the bolt goes into the lower hole soon™
- 2025-04-23
- Updated parts to have an angled printing version and adjusted fit some more.
Intro:
I was bored and decided I wanted to make my own version of the XP1 pedal hole plugs. My goals were to make the the face as flush as possible (curving the face of the shorter one), minimizing the gaps, and make them easy to mount and remove.
Notes:
- If your plugs aren't fitting, loosen the m6 bolts holding your pedal in place and re-center them in the holes. Because the plugs are a very tight fit, there isn't much wiggle room.
- The hole in the plug is to allow for removal. The hole goes opposite the bolt.
Printing:
- Print at 0.1mm layer height.
- The prints are oriented correctly.
- The plugs were designed with the shrinkage of ABS in mind (ABS shrinks about 0.6% in XY). If you are printing in a different material you may need to scale XY down by ~0.5%.
**************************************************************************************************
- Angled Print Plugs
- These pieces have curved faces that try to match the curves of the pedal.
- I included a set of plugs that are angled up around 45 degrees from the build plate to reduce the stepping you get with shallow slopes.
- These prints are a bit trickier because they don't have much contact with the build plate.
- Use Supports
**************************************************************************************************
- Flat Print Plugs
- These files are an easier print, but you will see the layer lines a bit more. They will still function pretty nicely.
- No supports required.
- Note on the lower bolt hole short plug.
- The Bolt head prevents completely flushing the face of the plug to the pedal.
