1 / 6
Lumon Macrodata Refinement Terminal - Raspberry Pi - based on Severance
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lumon MDR Terminal with a Raspberry Pi. Full project is on my site: https://erik.build/kb/Making/Lumon+MDR+Terminal
- Ocena
- 0 / 5
- Polubienia
- 34
- Pobrania
- 119
- Wydruki
- 0
- Wyświetlenia
- 955
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (38)Powiązane
Full project description and build log is on my site: https://erik.build/kb/Making/Lumon+MDR+Terminal
Printed in Overture PLA (White, Black, Matte Navy Blue). I printed the shell in 0.15mm layer height on it's back, with a brim and support touching the build plate only. I tend to use 3-4 perimeters and 15% adaptive cubic infill on my prints. The front and back panels I printed with a brim to keep adhesion high.
- Print all parts (see full build on my website).
- Attach the U Bracket to the base plate (secure with superglue).
- Insert magnets into shell and access panel (observe polarity so they don't repel each other!).
- Attach the Raspberry Pi 4 to the Raspberry Pi 7" Touchscreen.
- Insert the touchscreen assembly into the faceplate. Optionally secure with a little low-temp hot melt in the corners to keep it in place.
- Route the USB-C power supply cable through the access panel hole, attach to the right angle adapter, and then attach to the Raspberry Pi.
- Insert the faceplate assembly into the front of the shell.
- Attach the rear access panel to the shell (snaps together with the magnets).
- Attach the shell assembly to the stand, securing with the black knobs.
The work is mysterious and important.