Foamgasm Lynx Thumb Mag Release

Thumb release for ORION Lynx blasters.  Parts are set up for right handed users but can be mirrored for left hand use.  

The mag release lever requires an additional 3/32" diameter trigger pin that can be cut to length; 7/16" [11mm]. Some hardware kits already come with a spare pin.  A printable pin file is included, courtesy of bobmtran, but long term durability is unknown.

Linkage lengths are provided for Lynx, Minx, & Lonx, each with a Long and Short version.  

The “Long” version is suitable for large hands.  The “Short” version has the release moved 10mm rearward.  The +5mm or +10mm extended release can be used in either version.  The various combinations provide five different release positions covering a 20mm range. A small test receiver is included with reduced print time to allow testing the various release positions before committing to a full receiver print.  

** Note that the pin hole on the “Short” version is a blind hole going down into the grip.  The pin must be installed from inside the plunger tube. You will only be able to install the pin once. 

Included receiver cutout blanks can be used to subtract the required cavity from your receiver model of choice.  The cutout blank should be aligned with the receiver as shown below.  The rear midpoint of the rectangular cutout should be aligned with the rear center point of the receiver plunger tube bore.

Your grip model of choice will need to be modified with a 9mm wide x 3.5mm tall cutout.

Pre-Modified Pki Lynx Receiver & Grip

https://www.printables.com/model/1269521-pki-lynx-receiver-grip-for-foamgasm-thumb-mag-rele

Knurled grips for use with Thumb Mag Release

https://www.printables.com/model/1275936-foamgasm-lynx-grip-knurled/related