Lock or fastener for QG10-15 plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lock or fastener for QG10-15 plate.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Lock or fastener for QG10-15 steel plate. This fasteners are used for my zero point angle: https://www.printables.com/model/1269960-zero-point-angle-for-a-qg10-15-steel-plate-rectang
Be aware there are two different headers. The small one is for the angle. The bigger one if you want to use it stand-alone. You need M4 melting insert 4mm height. I use a screw to fasten the insert, but you can use any kind of M4 thumb screws. I use superglue to connect fastener with the head.
The fastening element works like a leaf spring. I uses PETG but PLA should work too.
Infill for header: honeycomb; 25%
Infill for fastener: straight line (in the longitudinal direction), 30%;
perimeter: 2; base&deck layer: 5; support for the holes
I've added another header for M4 countersunk screws if you need them
Attention: As always with my designs, you need a well calibrated printer. The tolerances of my designs are tight. No room for failures.
As a complete other successfully used idea: alternative you can use a 10mm rubber hose with a washer too. When you tighten the screw the hose is compressed and expands. That locks the cover element in place.