Lado Exhaust Duct - Low Profile Side Exhaust Duct for the Core One
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A low-profile side venting exhaust duct for the Prusa Core One.
- Ocena
- 4,8 / 5
- Polubienia
- 159
- Pobrania
- 280
- Wydruki
- 4
- Wyświetlenia
- 3377
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
General Info:
Duct protrudes 75mm from back face of printer.
I haven't done any super scientific tests, but I haven't been able to see a difference in cooling performance compared no duct. I'm pretty consistently 7-8C over ambient at 40% fan speed.
Print Settings:
There is presliced gcode for PETG if you want to print all 3 parts and not even think about settings. There's also a 3MF file with all the settings I used.
All parts are designed to print without supports. PETG is recommended because it has very strong adhesion with the Smooth PEI sheet that the Core One comes with. Just make sure you wait for your bed to cool all the way down before trying to remove PETG from the smooth plate. PLA should work as well, but I haven't tested. More warp-prone materials like ABS may require support, I wouldn't recommend trying this.
Screws:
M3 screws attach the hose adapter to the Lado duct. 8-10mm length is recommended.
Magnets:
This design uses 8x3mm magnets. Ideally the magnets should be installed with alternating polarity. They came out as a perfect friction fit for me, it's possible they may require superglue for some people.
Duct Interference Issue (Update: 9/1/25)
There is some intentional interference with the end of the duct and the corner of the printer. This serves to improve rigidity at the end of the duct and provide a more solid feel. That being said, a lot of people don't like this, and can even cause poor sealing around the fans in some cases. I have made an optional spacer to reduce/eliminate interference.
Don't want to use 100mm/4" hose?
I've posted a STEP file with interface geometry so you can create custom attachments for Lado.
STEP Files:
Step files for everything are downloadable. Warning: the model for the main duct quite rough, I was using this project to teach myself some new CAD techniques and things did not go according to plan. It may be challenging to modify cleanly.
What's at the other end of my hose?
For a while I just pointed the hose at the intake of a small Winnix air purifier. This worked okay, but obviously did not catch 100% of the smell.
I then upgraded to using a carbon filter from AC Infinity that's designed to be attached to 100mm hose. It requires slightly higher fan speeds for PLA (I use 50% normally, or 60% if my room is warm), but for any other material the stock 40% max fan speed keeps things plenty cool.
Several months later I found myself adding an inline 10mm fan to this filter setup and like it quite a bit. Much quieter than the stock fans, and more powerful. I've got it hooked up to a smart plug and Home Assistant, so it turns on when a print starts, and turns off 2 minutes after the print ends.