1 / 1
BIGTREETECH (BTT) ADXL345 Prusa MK3S+ Extruder Mount — zdjęcie 1

BIGTREETECH (BTT) ADXL345 Prusa MK3S+ Extruder Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple mount for the BTT ADXL345 for Klipper

Ocena
4,889 / 5
Polubienia
31
Pobrania
283
Wydruki
8
Wyświetlenia
1107
Oceny
9

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

This design replaces the extruder idler with one that has mounts for the BIGTREETECH (BTT) ADXL345 2.0 accelerometer board (https://www.amazon.com/BIGTREETECH-Accelerometer-Klipp-er-Connection-Stealthburner/dp/B0CHJQ6CXF) for use with Klipper firmware input shaper calibration.

It is not a full-time replacement and is only intended to be used during input shaping calibration. You must reinstall the original idler for printing.

To assemble you will need three M3 nuts and two relatively short M3 screws (6mm, 8mm…10mm might work but I haven't checked).