1 / 2
BMW R1150RT R1100RT extra running fog beam light (DLR) mounting bars — zdjęcie 1
1 / 2

BMW R1150RT R1100RT extra running fog beam light (DLR) mounting bars

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This are two Mounting bars specific designed for the R1150RT / R1100RT / R850RT BMW bike. LH and RH differ.

Ocena
5 / 5
Polubienia
3
Pobrania
42
Wydruki
1
Wyświetlenia
395
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This are two Mounting bars specific designed for the R1150RT / R1100RT / R850RT BMW bike. LH and RH differ from each other due to the different placement of the lefthand and righthand side cylinder head. Therefor I didn't want to mount them on the cylinder head protectors as that would give an asymetric light pattern what annoys me no doubt. 

So I designed these two bars that can be mount on the 2 screws above each cylinder for the bodywork / tupperware. I suggest you buy 4 25mm long M5 bolts to replace the 16mm original ones to be sure they grap the M5 speednut clamps. 

The V2.1 are almost perfectly lined out so that the horizontal as well the vertical angle is adapted to have the bars straight in line with the bike. 

I printed them in PETG and recommend to do that as well.

PLA or PLA+ is not resistant to the heat of the exhaust pipes that are too close. 

---- Dutch:

Dit zijn twee montagestangen die specifiek zijn ontworpen voor de R1150RT / R1100RT / R850RT BMW. De linker- en rechterzijde verschillen van elkaar door de verschillende plaatsing van de linker- en rechtercilinderkop. Daarom wilde ik ze niet op de cilinderkopbeschermers monteren, omdat dat een asymmetrisch lichtpatroon zou geven, wat me ongetwijfeld stoort.

Daarom heb ik deze twee stangen ontworpen die kunnen worden gemonteerd op de twee schroeven boven elke cilinder voor de carrosserie/tupperware. Ik raad aan om 4 M5-bouten van 25 mm lang te kopen ter vervanging van de originele 16 mm-bouten om er zeker van te zijn dat ze de M5 speednut-klemmen goed vastgrijpen.

De V2.1 zijn bijna perfect uitgelijnd, zodat zowel de horizontale als de verticale hoek is aangepast om de stangen recht op de motor te krijgen.

Ik heb ze geprint in PETG en raad je ten zeerste aan dat ook te doen. 

PLA of PLA+ is niet bestand tegen de hitte van de uitlaatpijpen die daarvoor te dicht bij deze stangen zitten.
 

Tagi