1 / 6
VW Audi (VAG) Bee String Aerial Seal (1K0 035 501) — zdjęcie 1
1 / 6

VW Audi (VAG) Bee String Aerial Seal (1K0 035 501)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A replacement aerial seal printed in TPU

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
71
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Public Domain

An alternative solution to replacing an obsolete VW bee string aerial seal, printed in TPU. Particular attention has been made to the raised rim on the underside of the seal, which presses into the roof panel to ensure a weather-tight seal.

It is recommended to use the .gcode files attached. The prints must be printed in the following sequence. :-

1). Printing Information (Aerial - Chamfer Insert). See images.

  • 0.10mm (DETAIL) layer height.
  • 15% infill.
  • 0.4mm nozzle diameter.
  • Prusament PLA was used.
  • No Support material is required.

2). Apply a glue stick to the surface of the above print and the surrounding print bed around the perimeter of the insert. Print the below part directly over the top.

3). Printing Information (Aerial Seal v4), See images.

  • 0.10mm (DETAIL) layer height.
  • 15% infill.
  • Lift height 1.0mm (Printers>Extruder 1)
  • 0.4mm nozzle diameter.
  • “Seam Painting” rear of the part, on the inside
  • Creality Black TPU was used (UV Resistant).
  • No Support material is required.

4). Rinse with water to release the insert, seal and bed from each other.