1 / 5
Sony SmartTV Remote Bumper
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bumper to protect Sony TV Remote
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- GNU General Public License v2.0
- This is designed to be printed without slicer dependent supports. Please do not use any supports.
- Designed to be printed standing up. The built in support T should be on the printers bed.
- Tested with 98A TPU and 95A TPU.
- I used .4 nozzle. The layer height was .2.
- How do you remove the support? Indeed this question is fun. So the supports will be fused with the whole model. Its only like .05 contact though. Its easily torn. I suggest wiggling it on the side. The wiggle should slowly tear along the edges fine. Just work your finger in along the edges. The hardest part is the top. From my prints, the support needed a good bit of movement to get it free. Try to get the supports to twist from the side and it should tear fine. I did this three separate times and it seemed fine, you couldn't tell it had supports.