Wanhao Duplicator 6 PLUS BLTouch Sensormount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mirrored BLTouch Sensormount designed by dot_bob. For the Duplicator 6 plus the left side would be better…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 624
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a mirrored BLTouch Sensormount designed by dot_bob. For the Duplicator 6 plus the left side would be better because the printhead fan is disturbing the rightside Sensormount. Please be aware that you have to adapt the marlin config files ! You can use the Marlin from dot_bob but you have to change the pins.ULTIMAN.h to your Pins
(eg: #define SERVO0_PIN 9 // PIN on little Printheadboard for BL-touch Servo
)
and you have to set in the configuration.h #define INVERT_E0_DIR true to false and
define X_PROBE_OFFSET_FROM_EXTRUDER -31 // X offset: -left +right [of the nozzle]
(https://github.com/dot-bob/Marlin-Duplicator-6/tree/1.1.x-bltouch)
Wire the BL-Touch:
Solder the pins of the little board on the printhead: 1 GND, 2 VCC, 3 Servo Signal, 4 Z-Min (look at the attached picture).
Modifications in Marlin (pins_ULTIMAIN_2.h):
Z-MIN maps to pin 29 and BL-SIG (servo) to pin 9.
Hans Coetzee traced a few more pins if someone will use it for the BL-Touch or a other project. I used Pin 9 and 29.
On J10, CTL is pin 10, BOTTON is pin 11. On J11, AC-DET is on pin A9. TX and RX goes to TXD2(pin 16) and RXD2 (pin 17).
Category: 3D Printer Parts