Ribbon Box (Trail Ribbon / Fährtenband / Markierungsband)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a little container with screw-on top to hold some trail ribbon / marking ribbon.I use this while hunting to mark…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Just a little container with screw-on top to hold some trail ribbon / marking ribbon. I use this while hunting to mark certain spots. One can tie something to the hole in the lid, I used a bit of Paracord and a small carabiner. The opening is large enough for 1-inch wide ribbon.
I've printed this in PLA with 0.2mm layer height and the thread works fine after screwing/unscrewing it a few times.
The Fusion 360 file is included. I've used a user parameter to set the height.
Category: Sport & Outdoors