1 / 2
1965 1966 Ford Galaxie 2 Gauge Pod
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1965 1966 Ford Galaxie 2 Gauge Pod using factory dash hardware.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 314
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Simple 2 gauge pod for a 1965/1966 Ford Galaxie or LTD. Uses the existing trim screws but need to be swapped for slightly longer #8-1" screws. Hangs 2x 52 mm (or 2") gauges and 2x 12mm (or ½") switch holes.
Prints in two parts, the bezel and the support bracket. They need to be glued together for the finished holder. I used epoxy.
Printed on 0.10 detail fast with PETG. PLA would work as well but I do not know about if it would sag in the heat.
Other parts:
- Epoxy - https://www.amazon.com/Gorilla-Epoxy-Minute-ounce-Syringe/dp/B001Z3C3AG
- Oil Pressure Gauge - https://www.amazon.com/dp/B00X047AE2
- Water Temp Gauge - https://www.amazon.com/dp/B00X8IKIXU
- 12mm Switch - https://www.amazon.com/dp/B075YV8KTG