Nerf Falconfire 15mm Barrel Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small accessory that allows to place a 15mm (aluminum) barrel for the Falconfire. Doesn't require any gluing nor screw
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Hey hey!
I was modding a Falconfire and decided to create a barrel insert for 15mm tubes. It can help if you intend to make it a single shot breach loader or a budget SPAMF conversion that has a cut mag slot. For this You don't need to glue or cut any part of the blaster. This fits neatly inside the front of the blaster (check how to install it on the pictures). It requires only both a M5 nut and bolt to tighten the tube in place, and works also with M4.
You have the main adapter piece to fit at the front, but you also have the option to place a “breach connector” inside, at the start of the tube. This piece helps to push the dart and place the breech's tip in the barrel. I recommend to print the two versions (normal and 0.5 offset) and see which one fits better. For the breach, I used a 3D printed one: https://www.thingiverse.com/thing:4943147
Because the barrel I used is slightly under 15mm of OD, I made two versions for most parts with a precise 15mm and then 15.2mm (the 0.2 tolerance should make them fit on normal 15mm).
Lastly, there's a small Suppressor piece. It's just deco, to add a bright colored end to the blaster. This project was just a short one, and soon will publish a new Nerf concept.
Hope this helps you in modding your falconfire!
Extra parts:
-M5 or M4 bolt and nut
Print settings:
-Infill: 20%
-Layer resolution: 0.2mm
-Brim: yes
-Material: PLA or PETG
-Support: yes, only for the adapter