NCASE M2 Case Raised Feet + IO version for M2 Grater

Update 26/04/2026:
- Added 15mm variant set.
- The hole for these variant is 4mm deep. This require either a M3x3x5 or M3x4x5 as inserts
- Replace the lower mounting hole as 2mm guide post instead. I wanted to try a different way to align the screw hole. From what I've tested with the 25mm variant, the outer screw point seems to already provide enough rigidity to the feet itself. If there's any issue, please let me know
- Offsetting the IO version so that it the female port is more closely align with the IO face as suggested by u/ormandj on Reddit. This changes applies to both 15mm and 25mm version.
- Re-organized file into height variant

I made a set of 25mm case feet that's compatible with most NCASE M2 variant.

There's 2 version of this set, the long O shape (Type A) and the U shaped (Type B)
All version uses M3 screws and does not block the bottom panel's screw holes.

Before printing, I recommend printing the test file to make sure the screw hole matches your final print. You can use it as a baseline to scale your model

Printed using Overture ASA on Bambu Lab P1S w/ 0.4mm nozzle, 15% infill, 3 walls. 
No support needed

You will need a M3 x 4 x 5 or M3 x 5.7 x 4.6 inserts for the insert version. There's also a regular version incase you don't use inserts like I did

I also made an IO version by rmixing NCASE IO feet onto the Type A version. Do note that I do not own the Grater version so I cant test for if there's any issue with it. If you did found one, let me know down below.