Bucket insert for plates, Eppendorf centrifuge 5910R, S-4X rotor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Deep insert for Eppendorf centrifuge 5910R, S-4X Rotor. Ideal for plates or stagetipping setup.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Chemistry & Biology
- Licencja
- GNU General Public License v3.0
Important:
Centrifuges can be dangerous, an unbalanced centrifuge can damage itself, any equipment around it or worst case humans in its vicinity! Print and operate this adapter at your own risk!
This is an insert for a bucket of the S-4X rotor that fits the 5910R Eppendorf centrifuge. The insert gives more depth allowing to either centrifuge a higher stack or more plates at a time.
The insert was tested at 4700G for 10 minutes which did not produce any failures. No long term tests were conducted thus far.
The prints tested were printed on an Ender3 out of PLA with a 0.4 mm nozzel, 50 % infill and 4 walls.
The greatest weight difference observed was ~6 g but as mentioned above check every print!
The Leibniz Institute of Virology is supported by the Freie und Hansestadt Hamburg and the Bundesministerium für Gesundheit (BMG).
Marius Lauffer, Charlotte Uetrecht and Pietro Scaturro acknowledge funding for VirMScan, from the Bundesministerium für Bildung und Forschung (BMBF 13GW0622).