1 / 1
The Filter for Voron 2.4 (by nateb) - 8mm Pogo remix — zdjęcie 1

The Filter for Voron 2.4 (by nateb) - 8mm Pogo remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Filter - A Nevermore Micro alternative 8mm Pogo remix

Ocena
5 / 5
Polubienia
10
Pobrania
60
Wydruki
3
Wyświetlenia
457
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Remixed to use 8mm pogo connectors for those brave enough to do some soldering.

These are the specific ones I used but I'd imagine most of the 8mm ones on Amazon or Ali come out of the same Chinese factory.  https://www.amazon.com/dp/B0D31Q12TH

Also added a couple alignment fangs to make sure you can't short the pogo without trying pretty hard.

Lid is unchanged from original but included here in case of upstream changes.

Slapped together quickly in TinkerCAD so no step files available.
 

2025-05-19: Applied the same changes to single fan side versions. Completely untested at this point.

Tagi