RPi Spy Camera Module Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Press fit protector case for the Raspberry Pi Spy Camera module.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 531
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Press fit protector case for the Raspberry Pi Spy Camera module, available from Adafruit, made specifically for the older models* where the camera itself could be easily separated accidentally from the cable. And yes, I found that out the hard way.
No supports are needed, and it takes only a handful of minutes to print.
*If you're not sure which model you have, check to see if yours has a tiny connector between the camera itself and a tiny circuit plate on the ribbon cable. Newer models that were released in 2019 do not have this connector, as seen in the illustration below:
