Harbor Freight Flag Pole Retainer Rings -- Starlink Dish
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Retainer Rings that help keep the HF flag pole sections from falling w/Starlink on top of it.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 264
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
These are the sizes needed for the 4 harbor freight flag pole sections. These retainer rings will help keep the flag pole from falling with a heavy Starlink satellite on top of it.
The internal friction rings in the HF flag pole operate with twisting force similar to some tripod legs / hiking poles /ski poles.
With large temperature swings and the weight of the the Starlink, we had a whole section of our flag pole slip and fall during the winter. The reduced dish height wasn't bad enough to loose internet service, but we didn't want more sections to fall – Jarring the internals of the dish.
These rings provide a 2nd piece of mind when installing your dish.
Use 4mm x 14mm or 16mm screws and Nylon lock nuts.
Printed in PETG with .2mm layer height, 6 walls, and 25% Gyroid infill. Could also print in ASA or ABS or any outdoor rated filament. Don't use PLA.
Rings were sized to have a very small gap at the ends so as to squeeze onto the flag pole and remain tight thru temp swings.