Frenchfinity - Anchored Plate version - Parametric Fusion360

i absolutely LOVE Frenchfinity! 
Check out the Creator @Bastelsaal for more Models for this system

The model lets you generate a 

• “wall anchor” / Cleat and a 
• “plate” / Support piece to gap between your cleats on the wall by simply changing a few parameters in Fusion360

A solid base for every frenchcleat holder i wanna create!
Also, if i decide to change stuff or reorganize or combine, its all interchangeable and i dont need to reprint a hole holder.
 

New in this Mode

did you ever lifted your tool from the holder and you accidentally rippt the holder from the wall? 
this has now a END! 

With this Model i added a small lip to the holder which allows you to add a small M4 Screw to fasten the holder against the Cleat. 
The best thing about it - you dont have to make holes to your Cleats. it just presses from the bottom against the Cleat.

solid until you decide to move it!
just use a allen key and fasten it or unfasten a bit to slide. if you decide to remove it, you have to do more turns until you can lift it off.

Screw position

if its a smaller peace you might be fine using one screw in the middle. 
if the holder is bigger, you cant access the middle part from below, so it is one on each side.

There is a specific configuration for filament safers - you can cut out the middle if its big enough

By changing the Configuration dropdown to “Cut”

On smaller holders, if the screwposition is in the middle, you need to leave it in "AllTrough" to dont cut the lip. (The default setting for just one screw is, if the width is smaller than 70, but you can change it in parameters if you want… )

Little help for your Quickstart

Parameters in Fusion360 you most likely wanna change:

1. wall_anchor_width = the thickness Wall Anchor, change it to the thickness fo your cleat (on the wall) in cm
2. width = width of the holder
    
3. base_plate_slot_height = the height of the entire holder from top to bottom
    
4. print_tolerance = its the “gap” between the parts to make stuff slide on and hold perfectly
   on my MK4s printed in PETG with 0.2 speed, 0.1mm is a perfect fit.
    
5. new parameters in this model you maybe have to change:
   base_plate_frenchcleat_height_gap = the gap for the Lip - default is 40mm which is enough for a 50mm cleat

Adjust this to your needs and you have your foundation for every holder you might print for your Frenchfinity in seconds!

Also worth mentioning - you might need to add the Plugin for parametric text

All frenchfinity projects are based on ParametricText by Thomas Axelsson.



since this is free, please consider liking, and sharing! 
This does costs nothing and supports creators at least a bit.

if you wanna support me, feel free to buy me a coffee :)