TRX4m Bronco rear gas can holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a jerrycan holder I made for the TRX4m Bronco. It can hold either the stock jerrycans from the Defender or my…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 465
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a jerrycan holder I made for the TRX4m Bronco. It can hold either the stock jerrycans from the Defender or my design, which can be found here: https://www.thingiverse.com/thing:6871004
It utilizes the stock hardware, and fits under the stock spare holder. It should be spaced just right to have a normal sized real spare mounted (~53mm diameter). Print facing up, as it is in the STL. You will need supports for the stalk - I recommend tree supports to have it easily removable.
I am still working on ways to secure the jerrycans onto the holder. For the time being, I will be using a rubber band. Not the most official way, but very effective.
If you print this, please post a make! It helps me gauge community engagement and know what I need to do better. Your feedback is incredibly helpful to me!
Print Settings
Rafts:
No
Supports:
Yes
I would advise fine resolution to preserve some of the small details.
Infill:
30%
Notes:
I just printed this at 30% infill, and it seems sturdy enough. I was worried about the thinness lending to structural instability, but that is fortunately not the case here.
Category: R/C Vehicles