1 / 4
CR-10 MAX LGN12H y axis top mount remix — zdjęcie 1
1 / 4

CR-10 MAX LGN12H y axis top mount remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

CR-10 MAX mounting bracket to mount bed to LGN12H linear rails on top of the 2020 extrusion instead of side

Ocena
0 / 5
Polubienia
4
Pobrania
9
Wydruki
0
Wyświetlenia
75
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Thanks to @Rasmus66 for his original model!

I am currently in the process of reworking CR-10 MAX with all electronics swapped for modern etc and my intention was to add a base (floor) under the bed, but i realised that by mounting  linear rails on the sides of extrusions they protrude slighly further than the bottom of extrusion and as a result i wouldn't be able to use extrusions as support from underneath. so i made quick adjustments to original design to mount linear rails on top of the extrusions.

I have only added 1 stl file so when printing mirror a part and print 2 parts.

Ok so i noticed small issue placing linear rails on top raises the bed higher and y axis belts where theyclip onto the bed mounts become slightly raised and as a result belt tension get drastically increased.

So as a solution i have added 16mm M5 stand offs (or 13mm + couple washers). placing them between bed mount and belt clips reduced them to correct size. * see image attached

Tagi