1 / 6
Fahrrad Flaschenhalter für 0,5l Flasche / Bicycle bottle holder for 0.5 litre bottle — zdjęcie 1
1 / 6

Fahrrad Flaschenhalter für 0,5l Flasche / Bicycle bottle holder for 0.5 litre bottle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Das ist ein Remix/Redesign des Flaschenhalters https://www.thingiverse.com/thing:5617983.Es gibt 2 Ausführungen:…

Ocena
5 / 5
Polubienia
14
Pobrania
174
Wydruki
1
Wyświetlenia
595
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Das ist ein Remix/Redesign des Flaschenhalters https://www.thingiverse.com/thing:5617983.

Es gibt 2 Ausführungen:

  • Flaschenhalter zum Schrauben, für Fahrräder mit Befestigungsschrauben für Flaschenhalter mit Abstand 64mm, s. Fotos.
  • Flaschenhalter zum Befestigen mit Kabelbinder für Fahrräder ohne Befestigungsschrauben. (Ohne Foto. Da ich diesen nicht brauche, habe ich ihn nicht gedruckt. Möglicherweise ist der noch verbesserungsfähig, wenn ihr dazu Tipps habt, dann her damit)

Beide Halter sollten passen für Flaschen bis ø66mm.

Sorry, kleine Korrektur kurz nach der Veröffentlichung: Ich musste die Bohrungen beim schraubbaren Halter um 5mm nach unten schieben, da ich sonst Probleme mit meinem Akku hatte. Nicht aufgepasst :(
Wer das Teil schon gedruckt hat und es passt- kein Grund zum neu machen.

------------------------------------

This is a remix/redesign of the bottle holder https://www.thingiverse.com/thing:5617983.

There are 2 versions:

  • Bottle holder for screwing, for bicycles with fastening screws for bottle holders with a distance of 64mm, see photos.
  • Bottle holder for fastening with cable ties for bicycles without fastening screws. (Without photo. As I do not need this, I have not printed it. It could possibly be improved, if you have any notes, please let me know)

Both holders should fit bottles up to ø66mm.

Sorry, small correction shortly after publication: I had to move the holes of the screwable holder down by 5mm, otherwise I had problems with my battery. Not paying attention :(
If you have already printed the part and it fits - no need to redo it.

Category: Hobby

Tagi