Husky Tool Storage Power Strip Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I hate the placement of this power strip on the side. I designed this as a blank so I could remove the power strip.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 410
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this to just slide up to lock it in place using the original screw.
You install it by aligning it to fit within the slots, then just sliding it up to put in the screw. It has a keyway that locks against the sheet metal to lock it in place.
I had a little difficulty with the screw side curling on my build plate so I recommend either using a mouse ear or brim to keep that flat.
I also designed this in two parts to fit most printers. You can superglue them together using the provided bowtie connector.