HSW - Rifle Rest for Scoped Rifles

ALL FUTURE MODELS WILL BE SHARED HERE:

https://cults3d.com/en/users/antirice/3d-models



I couldn't find a rest for my scoped rifles that I liked and was compatible with the Honeycomb Storage Wall, so I made these.

I ended up using only the narrow version for my needs, but went ahead and included all three sizes that I came up with. The narrow should fit a bare barrel (ie: bolt-action rifle or shotgun). The standard should fit over the handguard for an AR15 and the wide should fit over the handguard of an AR10, though no guarantees that they fit your particular model - this claim is just based off of measurements that I had.

You'll want to make sure that the inserts you use have a tight tolerance to both the HSW and the rest. They're quite stable when snugly installed, but I wouldn't trust them with a loose fit if I were you.

Printer: FLSUN V400
Filament: Duramic white PLA
Infill: 25%
Supports: One end of the rest is sloped and you'll need supports under that end.
Print with the bottom face flat on the print bed.

Please let me know if you have any suggestions/requests!
 

STEP files are included for your convenience. 

If you print this and you like it so much you want to contribute to my coffee fund, please do so here:

https://www.paypal.me/antirice

Don't forget to share your prints!

 

Original HSW here: https://www.printables.com/model/152592-honeycomb-storage-wall 

Installed with Andrew Frahn's standard size improved inserts here: https://www.printables.com/model/926144-honeycomb-storage-wall-improved-hex-inserts