Five33 Spec7 Street League - Printed-Parts

This is a set of 3D printed parts for the FlyFive33 Spec7 Street Legal 7" frame.

Canopy:
- The canopy side panels feature an air intake to help keep your electronics cool
- Print with “support on build plate” shoud be sufficient
- Use 30mm Bolts, to clip in the Canopy (12mm Arms + Battery-Holder)

Cam-Mount
- 45deg Angle for HDZero nano90 (micro V2 in the pictures)
- Print with “support on build plate” shoud be sufficient

Antenna-Holder
- for Foxxeer Lolipop V4
- second space to fit a capacitor

Battery-Holder
- for CNHL 2200mAh 5s
- designed with cutouts to place 5/10g tire balancing weights in the side
- Print upright and “support on build plate” shoud be sufficient

Fin
- designed to mount a 5mm COB LED strip around its edge
- To make the top-plate & fin detachable, it is recommended to connect the power cable with a plug. I used a red two-pin JST connector, which fits neatly into the rectangular pocket under the fin.

Arm-Protectors SMAL
- designed to fit COB LED strips arount the arm. However, it is recommended to use wire to bridge the very tip of each arm, as the strips could get damaged in the event of a harder crash