Refrigerator Drawer Divider for LG Fridge Beverage Drawer (LF30H8210S etc)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Additional drawer dividers for LG fridge beverage drawers.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 76
- Wydruki
- 1
- Wyświetlenia
- 739
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Refrigerator Drawer Divider for LG Fridge Beverage Drawer
Since the LG fridge only ships with one divider for the beverage drawer, the draw fits four, and they won't sell you any more, Davoxt saved the day with his model! (go show him some love on that Thingi_____ site). According to Davoxt, it is for LG model LF30H8210S, but I'm sure there are other models with the beverage drawer that it would fit.
When I was slicing the model to print, I noticed that due to the sharp, downward-facing corners, the supports never fully reached the model, and there was no support interface layer. To fix this, I simply flattened off the corners to allow supports to work better.
The two piece one will fit on larger printers (300x300), but the three piece one will fit on any printer 200x200 and larger.
Printing:
Dry your filament or you'll end up with a stringy mess.
Large layer heights work just fine. I used .24mm
Infill doesn't really matter since it's only in the edges anyway
Use tree or organic supports and support only on build plate to avoid touching other parts of the model with supports.
Use support blockers on the far front and rear round hooks. They don't need them.
I used PETG, but since these will be exposed to cold and not hot, I'm sure you could get away with PLA. I just didn't want them to be too brittle.
Assembly:
The dovetail joints slide together pretty easily. I added a drop or three of superglue on each end before sliding them together and they work perfectly!