Hydroponics: 90mm endcap for Veranda vinyl post
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 90mm cap for a Veranda vinyl-sleeved 8' post (narrower than normal 4" endcap). For hydroponics and NFT growing systems
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is for use with Veranda 4x4" by 8' vinyl-sleeved pine posts. I removed the post (reuse for other project) and kept the sleeve to be used as a hydroponic channel. Bought these when they were on sale: https://www.homedepot.com/p/Veranda-4-in-x-4-in-x-8-ft-Vinyl-Coated-Pressure-Treated-Pine-Fence-Post-with-Post-Cap-141601/203179280
I printed this with PETG, and used 5 perimeters and 20 bottom layers or so, to make sure it comes out solid.
To install it, inject a generous amount 100% waterproof silicone in the groove, and drill some small holes as “keys” in the very edge of the sleeve (¼" from the edge or so), then press on the end caps, clean up the excess, and let it cure overnight.
Use with these channel supports: https://www.printables.com/model/1296902-hydroponics-channel-supports-for-90mm-veranda-post