1 / 5
GMT800 LT Silverado / Tahoe / Suburban / Yukon Door Switch post repair (1999-2007) — zdjęcie 1
1 / 5

GMT800 LT Silverado / Tahoe / Suburban / Yukon Door Switch post repair (1999-2007)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This part helps repair the front post on higher optioned LT models that can break if the rear clip does.

Ocena
0 / 5
Polubienia
46
Pobrania
162
Wydruki
0
Wyświetlenia
2210
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

This part helps repair the front post on higher optioned LT models that can break if the rear clip fails.  Not all models use this front bolted post from the bottom.  

Print from ABS/PETG solid for strength.  Will need to use supports and put a minimum layer time for the upper layers.  After printing use a ¼" drill bit to clean up the hole and make for easy assembly without force.  Hold piece lightly in vice to avoid injury.  

Use a well fitting drill bit to realign post and reglue with an ABS glue.  I used SCIGRIP 16 but there are others that will work.  

After sufficient drying time I epoxied (30 min epoxy such as devcon) this 3D printed part on to drastically strengthen the post so it will not break again.  Clean original surfaces and scratch with a hobby knife to give something for the epoxy to bite into.  Apply glue to the post carefully avoiding getting any in the screw hole where the drill bit is aligning.  Before pushing home add glue to bottom surface.  I laid on its side and added glue to the back of the repair piece letting the epoxy level and forming a fillet.  After it tacked up i did the same for the other side.  

For armrest clip repair see:

https://www.printables.com/model/1280807-gmt800-silverado-tahoe-suburban-yukon-door-handle