Smiley - Talon Version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified smiley files to work with standard straight talon mags.
- Ocena
- 5 / 5
- Polubienia
- 88
- Pobrania
- 345
- Wydruki
- 9
- Wyświetlenia
- 2503
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A modified Smiley that uses more standard worker talon mags instead of nightingale/slim talons.
Hardware changes:
Largely the same, it likely does work fine with a standard hardware kit, but if you are able to, you can make the piece of 17/32" brass for the breech longer at 38mm instead of 33mm, and make the 3mm pins for the ram and bolt 33.5mm instead of 30mm.
The two internal bolt arms that connect the bolt to the ram remain the same as the standard Smiley, if you wish to fabricate metal priming arms for it.
Print changes:
Both halves of the receiver, outer part of bolt, breech housing, breech, bolt guide, large part of the triggerguard, mag catch, mag release bar, ram, and both frameplates.
Print settings:
Should be same as standard Smiley, STLs are currently not rotated into print orientation.
2025/12/4: Added handguard mount I forgor about.
WIP: Alternate handguards/receivers/stocks for better matching aesthetics with the new vertical magazine. Slim version of handguard and receiver is currently in the step file. Alternate mag release catch that sits slightly lower for Koda compatibility planned once I can get measurements. Working on adapting the new official o-ring pusher to this version.
Thanks to Goop for testing and photos while my printer gets exorcised. Blaster pictured is theirs with the slim receiver and handguard.