1 / 4
Faltbarer Petanque Abwurfkreis — zdjęcie 1
1 / 4

Faltbarer Petanque Abwurfkreis

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Foldable petanque throwing circle

Ocena
5 / 5
Polubienia
14
Pobrania
165
Wydruki
1
Wyświetlenia
448
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Hallo Zusammen!

Hier habe ich einen faltbaren Petanque Abwurfkreis mit einen Innendurchmesser von 50cm.

Die äußeren Pins müssen etwas eingepresst werden, weil sonst der ganze Kreis zu locker wird. Anschließend werden die Pins ineinander geklebt.

Für die Pins M3 werden eine Mutter M3, und eine  Sechskantschraube M3 X 5 benötigt.

Da die Schrauben nicht leicht zu bekommen sind, ist es möglich das Gewinde einer anderen M3 Schraube auf 7 mm abzusägen, und mit einer Mutter zu verkleben.

Pins: PETG  4 Wände - 100% Infill
Kreisteile: PETG  3 Wände  - 25% Infill

Viel Spaß damit.

 

Hello everyone!

Here I have a foldable petanque throwing circle with an inner diameter of 50 cm.

The outer pins need to be pressed in slightly, otherwise the entire circle will be too loose. Then the pins are glued together. For the M3 pins, you need an M3 nut and an M3 x 5 hex screw.

Since the screws aren't easy to get, you can saw off the thread of another M3 screw to 7 mm and glue it with a nut.

Pins: PETG 4-wall, 100% infill

Circle parts: PETG 3-wall, 25% infill

Have fun with it.

Tagi