ESP32 Cheap Yellow Display (CYD) Case for Bruce, Marauder etc

A compact version of my earlier CYD case available here. This version supports an external antenna. Supports are required for the base only, print both parts flat side down. I also have another version here.

The supports can be hard to remove from the stylus holder. I find the easiest way is to let the model completely cool and then try and yank it out in one go. Otherwise, inserting a small round file and giving it a few twists should grip the support enough for it to be cleanly pulled out. Some filaments are easier to work with than others, I found clear filament to be very brittle and so it's hard to cleanly remove the supports.

Here is a list of the parts I used. These are just suggestions and aren't affiliate links. You will find many suppliers selling the same parts if you don't already have them:

2mm x 6mm pan head screws for the screen (4 required) https://amzn.eu/d/hXnsqmH

2mm x 6mm countersunk screws to secure the case (3 required) https://amzn.eu/d/aygGhIW

Any NEO-6M compatible GPS receiver with a small antenna like this one https://www.aliexpress.com/item/1005001713388717.html

USB PD battery charger (1 required) https://amzn.eu/d/eAvlyjV

3.7v 1100mAH battery (1 required) https://amzn.eu/d/6Z9cKKQ

13mm x 7mm switch (1 required) https://amzn.eu/d/5Z2gyFK

Stylus (1 required) https://amzn.eu/d/5yUfBQd

Double-sided tape to secure the GPS module

U.FL to RP SMA lead

RP SMA Wi-Fi antenna

Optional belt clip (I use to clip to a car bracket) https://amzn.eu/d/gaYzSUS

Optional 4mm screws and nuts for the belt clip