Customizable Counterweight
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D-printable, customizable counterweight —ideal for astronomy gear, DIY rigs, or camera setups.By default,…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 101
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a3D-printable, customizable counterweight —ideal for astronomy gear, DIY rigs, or camera setups.
By default, it's designed to fit a standard20 mm counterweight shaft, and you can fill the container withBBs, sand, dirt, or similar materials to achieve a total weight of up to250 g (0.55 lbs). After filling, justtwist-lock the lid in place for a secure and convenient counterweight.
The mounting hole is designed to be tapped for either aM8x1.25 or5/16-18 nylon screw, 25 mm (1 inch) long, to firmly attach it to your bar.
Want to tweak it? You can easily adjust the following parameters to match your setup:
- counterweight_diameter
- counterweight_height
- counterweight_bar_diameter
- locking_screw_diameter
Print, fill, and balance—it’s that simple.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
No
Supports:
Yes
.2
Infill:
10
Notes:
Only the lid may need support.
Category: DIY