doublestack half dart magazine 32 rounds
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a 32 round half dart doublestack magazine based on Daniel Garcias prototype (link bellow)
- Ocena
- 0 / 5
- Polubienia
- 38
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 779
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Questions @ https://www.reddit.com/user/Ok-Shock-7736/
disclaimer:
The one problem I am still trying to improve is the latch mechanism, if u hit the mag at an weird angle too hard it can open the trapdoor and essentially “brick” the whole thing.
Also be careful with bad darts, if the darts are too far gone you can get feeding issues and potentially blow the flywheel motors.
loading:
1. load the left side like a normal mag until its full.
2. pull down the right follower through the right window and push the door in through the left window until the latch engages. (should stay closed)
3. load the right side untill full.
Hardware:
(2) full length talon springs
(1) 4.5x18mm tension spring
(2) torsion spring 4.6mm OD 0.5mm wire diameter
(1) comp. spring 2mm OD 14mm long
(10-14) m2x10mm toyscrew
(3x44mm rod
(3) paperclips or 150mm 0.8mm steel wire
Assembly:
U most likely need to use some sandpaper on a few parts incuding
the "top surface" of the “wall”
the sides of both followers
and the side of the “latch” that is making contact with the door.
1. insert the wall into the mainbody, with the cutout at the top. I wellded them together from the outside with an old Soldering iron.
2.
The latch should move freely, the spring is glued in with hotglue.
(you maybe need to experiment with the contact surface of the latch that engages with the “trapdoor”, you may need to adjust the angle with some sandpaper).
3.
3.1 cut one side of the torsion springs to 4mm and the other side to 8mm.
3.2 conect both doors with one 42mm wire piece.
3.3 insert the 3mm rod through both torsion springs into the top door.
3.4 insert the 45mm wire through the tension spring into the bottom door (shoud stick out on both sides).
4.
U may need to drill out the 3mm hole for the rod
4.1 insert the door assembly into the main body as seen in the picture.
4.2 push in the 30mm wire through the lose end of the tension spring into the mainbody.
the door should now automatically return to the open position when u close it.
5.
5.1 When inserting the followers as seen in the picture they should slide freely up and down.
5.2 insert the talon springs.
6.
6.1 put on the spacer and make sure the followers still move nicely
7.
put on the backplate and scew it in place.
THE END.
Original prototype by Daniel Garcia