Neptune 3 Pro extended filament sensor mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An extended filament sensor mount for large printheads.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
INFO
An extended filament sensor mount.
Note: You'll need to extend the filament sensor cable as it is too short. It is also recommended to use this mount with some sort of PTFE tube mod like this one:
https://www.printables.com/model/620936-elegoo-neptune-3-pro-filament-guide-with-filament-
REQUIRED HARDWARE
- M3 x 12mm screw (x 2)
- M3 x 16mm screw (x 1)
- Extended cable
ASSEMBLY
Use the two M3 x 12mm screws to mount the sensor to the spool holder. Tighten them down very much, the mounting bracket should sit at a good angle and shouldn't move up and down. Screw the 16mm screw fully into the sensor through the bracket. The sensor should be able to slide to the left and right.