Custom TPU Mounts for Rekon 4 LR Frame with Caddx Peanut Camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My custom 3D prints for mounting an FPV camera, RX dipole, video antenna, and Caddx Peanut to the Rekon 4 LR frame
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
These are custom TPU mounts for my specific build of the Rekon 4 LR Frame Kit. They were designed to mount the components I used but I figured I'd post this in case anyone was building a similar configuration and found these useful. I will also link the Onshape Project below if anyone wants to modify the designs.
All of these were printed out of TPU at 0.2 mm layer height, 3 perimeters, and 0% infill using a standard 0.4 mm nozzle.
Also important to note, I wanted a shorter deck height on my build so I used shorter M2 standoffs I found on NewBeeDrone. They have a thinner 3.5 mm diameter compared to the 4 mm diameter ones that come with the kit.
FPV Camera + 2.4 GHz Dipole Mount
I made two versions to fit 19 mm (micro) and 14 mm (nano) cameras. The part was designed to print flat and wrap around the bottom camera plate to also hold the 2.4 GHz receiver antenna.
Video Antenna Mount
This is a simple mount designed to friction fit onto the rear standoffs and support the VTX antenna. The antenna hole has a 4 mm inner diameter.
Action Camera Mount
These two parts hinge to allow for an adjustable camera angle. The action mount fingers are 3 mm wide with a 10 mm diameter and is designed to take a 20 mm M3 bolt. This is also designed to print flat and flex into shape when attached to the frame. I've always had trouble with rolling shutter wobbles “jello” so this mount was designed to help isolate the camera from frame vibrations.