Elegoo Centaur Carbon PTFE tube guide

On the new ELEGOO Centauri Carbon's the PTFE tube running into the print head is way too kinked and causes loading and printing issues.

If you have one of these machines please snip the small zip tie at the end of the tube guide and remove about ½ of the PTFE tube from its guide.
 

Put your PTFE tube through the new part and attach the PTFE tube to the print head as usual.

Then slide this awesome little gadget down the tube into place and finally snap it in. 

Top cover riser recommended ***not tested without a riser***

-SIMPLE PUSH IN DESIGN

-EASY INSTAL AND REMOVAL WHEN NEEDED

-STOPS THE TUBE FROM BENDING TOO MUCH AT THE PRINT HEAD

*** NOTE - this part is a tight fit use high quality print settings.***

*** print in PETG or better - ABS recommended ***