xTool F1 (Lite) Bottle Opener Keyring Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A plate to hold anodized aluminium bottle opener keyrings for the xTool F1 and xTool F1 Lite.
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 306
- Wydruki
- 2
- Wyświetlenia
- 768
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A plate to hold anodized aluminium bottle opener keyrings for the xTool F1 and xTool F1 Lite. It can hold 3 keyrings upright or upside down. The engraving heights are different for upright and upside down.
I printed this in PETG, but PLA or other materials work just fine.
---- Update ----
I've created the first design symmetrically. Unfortunately, the laser for the height alignment hits the jigs right in the middle. Due to the even number of recesses, none of them is in the centre. This means that the laser for height adjustment only falls on the printed holder, not on a bottle opener. I have therefore added further designs: Unsymmetrical, specialised and modular.
Symmetrical (holds front & back)
First design. The jig holds the objects, so you can laser front and back. (But not at the same time, because of different heights.) The laser for the height alignment doesn't hit any object.
Unsymmetrical (holds front & back)
The object holders have an offset of 5 mm. The laser for the height alignment can be used. To achieve this, it was necessary to create 2 versions: One with the front side in the middle & one with the back side in the middle.
Specialised (seperate design for front & back)
One specialised holder only for the front, and one only for the back. The laser for the height alignment can be used.
Modular (a 2-parted jig for both)
If you want to save filament or storage space, this might be the one for you. You only need one plate, which is divided into two parts. With this trick, you can chosse, wether the front side or the back side of the bottle opener is in the middle of the F1. Just place the small helping bar to one or the other side. (You might want to use it without the auxiliary bar, but then the laser is no longer enclosed in the device.)