Replacement knobs and latch for Fender Passport 300 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Broken latch? Sticky knobs? Here's the fix
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 333
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The knobs on this portable sound system were old and irrevocably sticky. So I popped them off and made new ones. Much better! These were designed to be as close as possible to the original looks of this particular sound system, but they'd probably fit others with a ~6mm keyed shaft.
Also one latch was broken, so I used the working latch to model up some replacement parts.
Printing
All parts recommended to print as oriented upon import.
Latch Parts:
0.2mm layer height
Small piece probably should be 100% infill or enough perimeters to make it completely solid.
Supports recommended
PETG
Knobs:
0.15mm (or finer) layer height for good looks
No supports needed
PETG
Post Processing
Remove support material and clean up with knife as needed. For knobs, the initial fit may be slightly tighter than desired. I found that pushing them on once, then prying off with a flathead screwdriver, then reinstalling them provided the right amount of resistance to pull off with fingers in the future if need should arise.