DIY Honeycomb Grid Godox AD200 / V1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
20° & 30° DIY Honeycomb Grid light modifier for Godox flash AD200 / V1 / AK-R1
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 309
- Wydruki
- 3
- Wyświetlenia
- 2353
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed a 20° and 30° honeycomb grid compatible with the Godox AD200 / V1 flash and the AK-R1 kit - that actually works. The included grid in the AK-R1 kit is a joke and does not work very well creating a small soft spot light. Be aware the honeycomb pattern is visible after you slice the 3MF files in Prusa Slicer! I use the infill instead of modeling the honeycomb because it prints much faster this way.
I use the honeycomb infill pattern because it creates a round spot light but takes 1 hour to print for the 30°. If you change the infill pattern to “Grid” change also the density to 25% check the screenshot above. Grid infill prints much faster (38 minutes) but it will produce of course a small square spot light when attached to your flash.
In the 3MF files, modifier and infill is already set-up just open the file in Prusa Slicer change your printer, filament, slice and print. I used the 0.30mm DRAFT mode with ironing activated. My filament was Extrudr Greentec Pro Black because it has a matte finish but you can use PLA or PETG of course.
More infos on my blog here:
https://www.schweinert.com/diy-grid-godox-v1-ad200/