Philip's Hue Light Strip Clip for Ikea Lack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clips to help secure Philip's Hue Light Strip to an IKEA Lack/Flat Surface
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 854
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Clips to help secure Philip's Hue Light Strip to an IKEA Lack/Flat Surface
Print instructions
Category: DIY Print Settings
Printer: Anycubic i3 Mega
Rafts: No
Supports: No
Resolution: .3
Infill: 15%
Notes:
No Supports needed
15% Infill with PLA at .3 resolution
15% infill was PLENTY strong
For mounting I used mounting putty/sticky tack/poster putty, which is a putty that does not harden and does not leave any residue behind or destroy surfaces it comes into contact with. The LED light strip is light enough that once the putty has cooled down it stays in place, HOWEVER I have found that if you keep the lights on at maximum brightness the strip does become hot enough to soften the putty up which causes the mounts to come loose.
If you're looking for a more stable adhesion I'd recommend double sided tape, but this may damage the surface it comes into contact with.